5101100SP097 Technical Profile    Application Target/Tactical

Barrel Bore Diameter: 0.500" 12.690 mm The diameter of the barrel from land to land.
Barrel Groove Diameter: 0.509" 12.920 mm The diameter of the barrel from groove to groove.
Bullet Weight: 1100gr 71.3g Bullets are guaranteed to weigh within 0.25% of the stated weight.
Bullet Length: 3.38" 85.920 mm
Tangent Ogive Length: 1.78" 45.166 mm These dimensions are critical to consistent external ballistic performance and are held constant to within 0.005 mm (0.0002")
Meplat Diameter: 0.05" 1.269 mm
Min Bullet Protrusion: 1.88" 47.670 mm Add the case length to these numbers to determine the maximum and minimum cartridge overall length (COL) that is possible with this bullet.
Max Bullet Protrusion: 2.56" 65.000 mm
CIP and SAAMI cartridge overall length (COL) not observed or does not apply. Check the COL of your rifle for suitability with this bullet as described above.
Maximum M/V: 3700fps 111 m/s If the maximum muzzle speed is exceeded, dynamic stabilty problems may be encountered.

Twist Rates are guidelines but the Minimum Twist must be observed 

Twist: Sg = 1.4: 10.8" / 274 mm or tighter 21.6 Calibers or tighter The twist required to give a calculated Sg 1.4
Minimum Twist: 11.5" / 292.1 mm 23.0 Calibers The slowest twist required for stable flight and the best long range tractability more than 1100 yds or 1010 m. See the 'Notes' below.

Calculated Ballistic Coefficient - Standard Metro G1 profile

BC = 1.736 Maximum M/V to 2450 fps Maximum M/V to 239 m/s Any comparison with the BC values of other manufacturers is not valid as there is currently no standard method in use between manufacturers.  These BC values are only for use in an external ballistics program. Use the three values, as given, to approximately calculate BC for your launch speed and distance. For exact numbers, shoot drop tables at the elevation and temperature for your location.
BC = 1.492 2450 fps to 1200 fps 239 m/s to 366 m/s
BC = 1.121 1200 fps to 0 fps 366 m/s to 0 m/s

Suitable Cartridges, with consideration of the above specifications:

50 BMG and others.


A Gyroscopic Stability (Sg) greater than 1.2 is required for SP bullets. For use under 730yds/670m an Sg of up to 1.5 or even greater can be used. For distances beyond 730yds/670m, the Sg can be decreased with a slower twist, but never less than 1.2 for GSC SP bullets.
*Note that Sg increases as twist tightens.  *A 1:10" twist is tighter than a 1:12" twist within a given caliber only. *Twist rates given in caliber lengths can be compared across calibers. *Choose a bullet length best suited to your rifle twist and type of shooting.  *When a bullet is specified for a given twist rate, it can also be used in any twist that is tighter.  Using it in a slower twist than specified, is not advisable. *Some experimentation will be required to determine exact drop tables for your equipment and location.