323245SP012 Technical Profile    Application Target/Tactical

Barrel Bore Diameter: 0.315" 8.000 mm The diameter of the barrel from land to land.
Barrel Groove Diameter: 0.323" 8.200 mm The diameter of the barrel from groove to groove.
Bullet Weight: 245gr 15.8g Bullets are guaranteed to weigh within 0.25% of the stated weight.
Bullet Length: 1.93" 48.900 mm
Tangent Ogive Length: 1.08" 27.443 mm These dimensions are critical to consistent external ballistic performance and are held constant to within 0.005 mm (0.0002")
Meplat Diameter: 0.03" 0.800 mm
Min Bullet Protrusion: 1.16" 29.520 mm Add the case length to these numbers to determine the maximum and minimum cartridge overall length that is possible with this bullet.
Max Bullet Protrusion: 1.50" 38.000 mm
Bullet does not conform to CIP and SAAMI for magazine length. Check the magazine length of your rifle for suitability with this bullet.
Maximum M/V: 3500fps 1 067 m/s If the maximum muzzle speed is exceeded, dynamic stabilty problems may be encountered.

Twist Rates are guidelines but the Minimum Twist must be observed 

Twist: Sg = 1.4: 7.7" / 194 mm or tighter 24.3 Calibers or tighter The twist required to give a calculated Sg 1.4
Minimum Twist: 8" / 203.2 mm 25.4 Calibers The slowest twist required for stable flight and the best long range tractability more than 660 yds or 610 m. See the 'Notes' below.
Calculated Ballistic Coefficient - Standard Metro G1 profile
BC = 0.903 Maximum to 2350 fps Maximum to 716 m/s Any comparison with the BC values of other manufacturers is not valid as there is currently no standard method in use between manufacturers.  These BC values are only for use in an external ballistics program. Use the three values, as given, to approximately calculate BC for your launch speed and distance. For exact numbers, shoot drop tables at the elevation and temperature for your location.
BC = 0.793 2350 fps to 1200 fps 716 m/s to 366 m/s
BC = 0.587 1200 fps to 0 fps 366 m/s to 0 m/s

Suitable Cartridges, with consideration of the above specifications:

8mm Rem Mag, 325 WSM


A Gyroscopic Stability (Sg) greater than 1.2 is required for SP bullets. For use under 660yds/610m an Sg of up to 1.5 or even greater can be used. For distances beyond 660yds/610m, the Sg can be decreased with a slower twist, but never less than 1.2 for GSC SP bullets.
*Note that Sg increases as twist tightens.  *A 1:10" twist is tighter than a 1:12" twist within a given caliber only. *Twist rates given in caliber lengths can be compared across calibers. *Choose a bullet length best suited to your rifle twist and type of shooting.  *When a bullet is specified for a given twist rate, it can also be used in any twist that is tighter.  Using it in a slower twist than specified, is not advisable. *Some experimentation will be required to determine exact drop tables for your equipment and location.